9/16/2023 0 Comments N64 main board![]() ![]() 'G' (modding board) ⇄ VDC-NUS(A) pin 19 (N64 main board).'R' (modding board) ⇄ VDC-NUS(A) pin 17 (N64 main board).solder a wire from the via next to R16 (N64 main board) to pad 'CS' (modding board)ĭouble-check continuity between connections:.solder a wire from the via next to R10 (N64 main board) to pad 'B' (modding board).solder a wire from the via next to R9 (N64 main board) to pad 'G' (modding board).solder a wire from the via next to R8 (N64 main board) to pad 'R' (modding board).solder the modding board onto the pins of the MultiOut.isolate the bottom side of the modding board to avoid any shorts.This avoids the shielding from hitting the modding board later. Use a pair of pliers to bend away the tab which is located at the MultiOut area. Install instructions Bottom metal shielding If that's not the case - stop here! Your console is not compatible with this modding board! This modification only works with NUS-CPU-01/02/03/04 main board revisions!Īlso, verify that your main board has a 'VDC-NUS'/'VDC-NUS A' chip (U4). ![]() Use 0.8mm board thickness to ensure an easy and clean installation. Of course, feel free to use the gerber files with any manufacturer of your choice. You can order the PCB directly from OSHPark. ![]() A modding board to achieve RGB video on some early NTSC models by using TI's THS7374 video amplifier. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |